Page 1 of 1
Posted: Mon Jul 04, 2005 5:54 am
by analyst
Hi there....
i just connected my new computer and i noticed that i have a low level of input to my pulsar.....
it never happend to me before.... i had a old computer that work with the same card and he didnt had any problem ????
what it can be ?
Posted: Mon Jul 04, 2005 6:06 am
by at0m
No idea, but have you tried feeding a normalised analog out straight back to the input? Is it still that loud? Check on the VU meters...
Posted: Mon Jul 04, 2005 9:53 am
by Music Manic
Which input? analogue,adat?
Posted: Mon Jul 04, 2005 10:29 am
by garyb
of course you know, if you feed it a microphone, you'll need a mic preamp....
<font size=-1>[ This Message was edited by: garyb on 2005-07-04 11:30 ]</font>
Posted: Tue Jul 05, 2005 12:06 am
by blazesboylan
-10/+4?
Posted: Tue Jul 05, 2005 8:14 pm
by analyst
sorry... i forgot....
i'm using the analog input.....
and my signal is even low at the pulsar mixer.
Posted: Wed Jul 06, 2005 5:43 am
by Music Manic
That's normal,analogue has low level noise.
Posted: Thu Jul 07, 2005 5:51 am
by analyst
so what do you say's over here is that i need to connect preamp to my input and then to connect everything to my preamp ????
i didnt was like that before i bought the new computer...........
Posted: Thu Jul 07, 2005 8:43 am
by garyb
if it's a microphone that you're recording....