Pulsar v1.01 low input problem

analyst · Post by **analyst** » Mon Jul 04, 2005 5:54 am

Hi there....

i just connected my new computer and i noticed that i have a low level of input to my pulsar.....

it never happend to me before.... i had a old computer that work with the same card and he didnt had any problem ????

what it can be ?

at0m · Post by **at0m** » Mon Jul 04, 2005 6:06 am

No idea, but have you tried feeding a normalised analog out straight back to the input? Is it still that loud? Check on the VU meters...

Music Manic · Post by **Music Manic** » Mon Jul 04, 2005 9:53 am

Which input? analogue,adat?

Post by **garyb** » Mon Jul 04, 2005 10:29 am

of course you know, if you feed it a microphone, you'll need a mic preamp....

<font size=-1>[ This Message was edited by: garyb on 2005-07-04 11:30 ]</font>

blazesboylan · Post by **blazesboylan** » Tue Jul 05, 2005 12:06 am

-10/+4?

analyst · Post by **analyst** » Tue Jul 05, 2005 8:14 pm

sorry... i forgot....

i'm using the analog input.....
and my signal is even low at the pulsar mixer.

Music Manic · Post by **Music Manic** » Wed Jul 06, 2005 5:43 am

That's normal,analogue has low level noise.

analyst · Post by **analyst** » Thu Jul 07, 2005 5:51 am

so what do you say's over here is that i need to connect preamp to my input and then to connect everything to my preamp ????

i didnt was like that before i bought the new computer...........

Post by **garyb** » Thu Jul 07, 2005 8:43 am

if it's a microphone that you're recording....