Page 1 of 1

Posted: Sat May 03, 2003 8:59 am
by Thalamus
Hi there,

I think its pretty stupid that fx the asio drivers is reloaded with every project. When it does that, all my routing in my DAW is ruined. Actually, I have to restart My DAW nearly everytime I switch SFP project to have no issues.

Wouldn't it be possible to have an option (in the settings) to choose between stationary ASIO drivers (so fx 24 channels is allways available) or do normal reload.

_________________
Yours truely

Noah Laux

<font size=-1>[ This Message was edited by: Thalamus on 2003-05-03 10:01 ]</font>

Posted: Tue May 06, 2003 5:32 am
by mr swim
Yeah, its really annoying isn't it ! ?

Have a feeling that its not possible because of the floating point architecture of the DSPs though.

(just a guess)

I'm sure they would have tried to do it if they could, wouldn't they ?

Posted: Fri May 30, 2003 12:50 pm
by orbita
I know its not neat but what I do is to set my sequencer (cubase) to one of the direct sound or mme drivers while i switch project to prevent it erroring and potentially crashing. Then, when the new project is loaded I switch back to scope asio

Posted: Fri May 30, 2003 1:56 pm
by Thalamus
Well, that's actually a good work-a-round, thanks. But anyway, I'ld still like a smoother solution.

Posted: Fri May 30, 2003 3:32 pm
by j9k
i agree......

j9k