PlanetZ forums - scopeusers.com

Hi ppl!!

i have this problem...

my machine: mac dual g4 867Mhz mac OS 9.2 and Luna II with luna software (no sfp) running cubase VST32 r1. the midi in cubase doeasn't work. With a midi monitor in luna environment it works. So what's the trouble??
Should I use sfp software??

Welcome to PlanetZ!

You didn't specify if you did right cabling in the luna environment (besides cubase VST32r1 <- ?). Did you make your luna OMS setup? Did you include luna sequencer in/out modules in the setup? Is the luna software loaded while cubase work? The answers are YES to all, I presume so your trouble is you have to make 'play in background' settings both in OMS setup and cubase. I hope this helps

About using or not SFP. You can see benefits only using sfp - it's more stabile etc.

<font size=-1>[ This Message was edited by: samplaire on 2003-01-28 07:28 ]</font>

well...
in the environment all is ok. there are a sequencer source and a destination connected to the luna midi hardware module.

the only strange thing is that in the oms set up luna in/out isn't appeared. what should i do for this??

Best R.

thank in advance. Noname

If only the CW icon(s) appear in the OMS setup then everything is ok. But if it doesn't appear.... Look in the Luna folder and find the LunaOMS or CreamWare OMS (don't remember the name but it should end with OMS). Move it to the oms folder (the one in the system folder). Then - launch the luna software (with all midi cabling), launch oms setup and create new one. Then in the oms setup find the 'play in backroound' setting and activate it. The same in cubase.

a serie of luna was sold with bad cables ...
u can ask new midi cables for ur luna to ur creamware shop ...
i am a reseller and i had this problem with many clients ...

thank to all!!

i'll check this tonight!!

stay tuned!!!

bauzzzz