PlanetZ forums - scopeusers.com

Hi!
Could someone please make me a graf.example in the project window of
Luna II to show me how to connect my STS3000 to recording mix, to modules end to efects. I use CubaseVST32/5.0 with LunaII end Powersampler!

Thanks for any help!
E-Mail SLAVU@gmx.net

Hi Hippo. Projects are going to vary depending on what midi ins and outs you have or want. Basically, try and get your midi controller keyboard to go direct to Cubase. (this can be done by connecting midi source straight to midi dest in your project - if you're connected by midi cable)Then load up a 'sequencer midi source' module into your Pulsar project. Connect this to the midi in on the left of the sts3000. Then connect the main out to the mixer. This should be all you need to start with.

hope this helps,

Good luck,

Will.

Thanks for your help!!!!!!!!!!