Scope software on Luna II

Nebukadneser · Post by **Nebukadneser** » Wed Oct 02, 2002 2:32 am

I am running the impressive Scope installation of the SFP 3.1 on my little Luna II card. I have been overwhelmed by the amazing sounds of the devices such as the Vectron, Modular and the SB404 Arpeggiator. I obviously need more DSP power to expand the polyphony, and I consider buying a Pulsar I. Would it be possible to link the Luna II and the Pulsar I to utilize the merged DSP power? The ULLI settings of the two cards are not compatible as the Luna can achieve 3ms latency and the Pulsar only 13ms.

spoimala · Post by **spoimala** » Wed Oct 02, 2002 3:15 am

Yes it is possible! Pulsar I doesn't have ULLI but when they are linked together, the system will use LUNA as interface to PCI-bus.

at0m · Post by **at0m** » Wed Oct 02, 2002 9:41 am

Combining CW cards is the easiest thing:
the software will act like there's just one card, will the total number of DSP's and IO's, and running on the latency of the fastest of them.

If you don't need the IO's of Pulsar1, there's SRB's for sale in the Purchasing forum.

mr swim · Post by **mr swim** » Wed Oct 02, 2002 4:18 pm

definitely go for the SRB if you don't need anything but chips, but I would say (although it sounds like you might have a good deal waiting for you . . .

) that you may as well go for the Pulsar II - more chips (i believe) and more goodies (i think)