Page 1 of 1
Posted: Wed May 08, 2002 12:43 pm
by sandrob
i do clean xp instal.
then sfp
then cubase....
i don't have asio scope in cubase's audio setup?!?!
only full duplex!??
Posted: Wed May 08, 2002 12:56 pm
by janila
I bet you tried to reinstall SFP after the Cubase?
Posted: Wed May 08, 2002 1:04 pm
by sandrob
thanks, janila!
i didn't unistal nothing - just over-instal SFP and now is ASIO SCOPE aviable in cubase
Posted: Wed May 08, 2002 1:11 pm
by at0m
On 2002-05-08 13:56, janila wrote:
I bet you tried to reinstall SFP after the Cubase?
Yes. :|
Thanks, I had some problems!!
Posted: Wed May 08, 2002 1:26 pm
by sandrob
On 2002-05-08 14:11, at0mic wrote:
On 2002-05-08 13:56, janila wrote:
I bet you tried to reinstall SFP after the Cubase?
Yes. :|
Thanks, I had some problems!!
if i can help?!
_________________
<font size=-1>"got my mojo working, but it just won't work on you"</font>
<font size=-1>[ This Message was edited by: sandrob on 2002-05-08 14:27 ]</font>
Posted: Wed May 08, 2002 1:41 pm
by subhuman
I had Logic 4.81 installed, then installed SFP along side my Pulsar301 install, and never had any problems with it...
Posted: Wed May 08, 2002 2:10 pm
by paulrmartin
Me neither, Sub. Why the question marks?
Posted: Wed May 08, 2002 2:26 pm
by janila
I've had somewhat all the installation problems mentioned here with SFP and earlier software versions. For some reason my Creamwares always works best when everything else is installed and I then reinstall the drivers and install the software. Seems obvious but still..
