Page 1 of 1
Posted: Sat Mar 09, 2002 5:43 am
by sandrob
i just substitute my old secondary master ibm30gb disk with ibm120gb. i set jumpers and everything like was before, but i can't see this disk in explorer. windows detect new device on startup but i don't see disk in win explorer? i see disk in bios, but not in windows?!
<font size=-1>[ This Message was edited by: sandrob on 2002-03-09 06:06 ]</font>
Posted: Sat Mar 09, 2002 6:06 am
by Spirit
I just installed a new drive a few days ago. You must fdisk the drive. See step 18 in this guide:
http://www.seagate.com/support/kb/disc/ ... d_ata.html
Posted: Sat Mar 09, 2002 6:08 am
by sandrob
yes, yes!! i see!! i just creating primary dos partition!
thanks, spirit!!
Posted: Sat Mar 09, 2002 6:50 am
by sandrob
finaly works
<font size=-1>[ This Message was edited by: sandrob on 2002-03-09 07:33 ]</font>
Posted: Mon Mar 11, 2002 1:59 am
by Micha
you also can fdisk it as Extended Partition. In this case it will just add drive letters. Example: 2 disks with 1 primary and 1 Extended formatted as 2 letters C and D: Result is:
C of #1 is C, C of #2 turns D, D of #1 turns E and D of #2 F.
So if you want to have C and D of #2 as E and F you simply fdisk #2 as Extended Partition.
