Page 1 of 1

Posted: Wed Feb 20, 2002 7:10 pm
by vaporubs
Anybody using this with a pulsar 2, and how is it working out? I'm considering this board.

Posted: Wed Feb 20, 2002 11:04 pm
by kurst
:smile:

as I said in another thread I'm considering it too ...

ANyway I saw in alot of threads (in this forum too) that alot people own it and are very happy so I think I'll go for it...
Other Rimm mobos as Abit imho are far after the P4T-E (according to the review on the internet)and have some stuff on board that maybe can cause some problems to Pulsar and the PCI widht ... such as the third party controllers for ATA100 or Raid...

Bye bye

Posted: Thu Feb 21, 2002 4:38 am
by sandrob
i use p4t-e same sucessful as my good old cusl2 but with more cpu power! :smile:

_________________
"without deviating from the norm, progress
is not possible" - frank zappa


<font size=-1>[ This Message was edited by: sandrob on 2002-02-21 04:40 ]</font>

Posted: Thu Feb 21, 2002 8:49 am
by subhuman
One of my favorite motherboards P4TE. There is one version that can hit 133FSB (it has "ICS" on the chips near the RDRAM slots), so if you plan to clock, you will need a P4TE board with the ICS chips, and to hit 133FSB you should use the jumpers (the BIOS doesnt give the proper divisors at 133mhz). Because of this, ASUS P4B266 might be better since it is easier to overclock. But at speeds beyond 2200mhz, DDR doesn't feed quite enough memory bandwidth to the bandwidth starving P4 - there is a pretty steep performance gap at those higher (future) speeds...