Page 1 of 1
					
				Re: Z-Link Plate  for sale
				Posted: Sun Apr 16, 2023 10:54 am
				by yayajohn
				What does the floppy disk power drive connector do?
Does Z-link need extra power?
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Sun Apr 16, 2023 4:02 pm
				by valis
				One of the ADAT ports would need power, the Z-Link would make sense too given the fact that it uses Firewire. There's a lot of buffering and a fair sized chip sitting on that card.
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Sun Apr 16, 2023 10:58 pm
				by rawkhard
				valis wrote: Sun Apr 16, 2023 4:02 pm
One of the ADAT ports would need power, the Z-Link would make sense too given the fact that it uses Firewire. There's a lot of buffering and a fair sized chip sitting on that card.
 
Hey Valis
Maybe you can help me 

What is the going rate for a syncplate(?) (wordclock) extension / Ad-on Card
cheers
 
			
					
				Re: Z-Link Plate  for sale
				Posted: Mon Apr 17, 2023 12:11 am
				by valis
				I don’t know, I would have to scan the forums and see if there’s any offers visible that were settled in the thread. Perhaps try that?
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Mon Apr 17, 2023 12:32 am
				by rawkhard
				found one already but no sale, i´ll keep looking, thanks 

 
			
					
				Re: Z-Link Plate  for sale
				Posted: Wed Apr 19, 2023 3:25 am
				by valis
				Gary, will that ZLink plate connect to an Xite?
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Wed Apr 19, 2023 7:08 am
				by garyb
				i don't think it's a good idea. i believe the Z-link connections have power. they do on the Luna Expansion for sure.
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Wed Apr 19, 2023 9:35 am
				by nebelfuerst
				Even if Z-Link would allow some scope/xites to connect:  Is there a Slave-mode in Z-Link ?
(My A16u doesn't allow slave in Z-link-mode)
			 
			
					
				Re: Z-Link Plate  for sale
				Posted: Wed Apr 19, 2023 12:12 pm
				by valis
				garyb wrote: Wed Apr 19, 2023 7:08 am
i don't think it's a good idea. i believe the Z-link connections have power. they do on the Luna Expansion for sure.
 
Glad I put that out there.  I don't have a need, but since this plate isn't moving that question would have come up eventually.