PlanetZ forums - scopeusers.com

I use tapeecho and stereocomp in a project.

When loading the project, the two devices are always opened.
I can close them and save the project, but they popup on load again.

What is the reason for this behaviour ?

Hi, try to close them, save the screen set, save the project.

Just tried it again.
All dna-devices open their windows, no matter if they were closed on save or not.
All other devices seem to remember their closed state.
Is there a special button on dna which makes this behaviour ?

Hi, it works here, have you tried to:

1. Close the DNA device GUI
2. save the actual screen set by unlocking the padlock and locking it again
3. save the project

Exactly.
Other plugs need this done as well. Because they are screenset capable.
Great feature I find difficult to not have.
When using FX as inserts, it’s a pain in the ass to open the mixer, then open the plug in, etc.

So to save a screenset of a certain effect or combination of them, open a mixer, open said inserts, delete the mixer from the screen, put the effect(s) where you want, then save the screenset.

Now when you need more wet mix of a reverb, etc. Screenset #4/ALT 3 brings up Plate X.

Glad you’re okay DJM.

Cheerz

Thank you very much !
I never recognised that screenset function, although I watched the screen of scope for decades.
Now my screen comes up clean, as I prefere it most of the time.
But maybe the screenset will become usefull to me. I'll start playing around on my next scope session.

I use about 8 to 10 screenset.
MIDI Monitors, a certain effect.
STM mixer views.
AUX channel views, etc.

dawman wrote: Tue Jul 07, 2020 5:29 am I use about 8 to 10 screenset.
MIDI Monitors, a certain effect.
STM mixer views.
AUX channel views, etc.

Jimmy is our:

That’s a great head shot of Scope.
Is that new?

A few decades in the making