PlanetZ forums - scopeusers.com

Hi

Sending audio Ramp to Flexor
I manage that from Cubase : one cycle ramp on each bar and it work!
So I did bounce that ramp to a file : 120bpm_1Bar
load it in Renoise in the sample player = not working
Then in a sampler : Bliss, Independence, Falcon = not working

Any body any ideas ?

Thanks

controlling Modular sequencers externally (by sending a Ramp signal from your DAW) works quite perfect.
Give the Ramp signal a specified Asio output, connect it to Modular, and you're good to go (but be careful not to connect it to the audio mixer, otherwise you'll ruin your headphones/speakers).

Depending on your DAW, you'll probably have to check what time stretch method is most appropriate to have a tight rhythm.

If nothing is happening on the Modular side you have a connection problem (check the Modular input signal with a ValMeter module).

HI Roy

It is perfect I agree !!!
But
Renoise is refusing to send it properly.... Cubase fine, Samplitude fine, etc
I'm starting a project and Renoise is the best for doing the job... but no Ramp

Do you see the waveform properly? Maybe in saving the ramp as wave, something is bad.

You can generate a sawtooth wave, use a simple LFO, or synth to send the audio ramp, just tune it to 2Hz for 120bpm and capture the wave again.

I just got back to that project yesterday
And... After spending couple of hours trying this and that,
I found that in Renoise on the Master track, the DC filter check box was tick !!!!!
I felt stupid
but then I was surprise that the DC offset is apply to all outputs not just the master.
Happy Renoise user now!!! I got an audio Ramp to MODular IV, from 30 to 999 bpm without having to change anything !
Cheers