PlanetZ forums - scopeusers.com

Is it possible to use another audio driver like asio4all with the XTC synths running?

may seem like a daft question but there is a larger latency under XTC mode isn't there?

I would try it out but I'm away from the PC at the moment with Scope on.

Thanks in advance........

fraz wrote:there is a larger latency under XTC mode isn't there?

I'm afraid the latency is inherent to the signal path used in XTC mode, ie. for audio: Cubase > DSP > Cubase > DSP > out. A trick to reduce latency when using multiple XTC FX on a single channel is to stack them in a Scope Multi-FX, as to prevent latency from accumulating in a channel's insert FX chain. This avoids excessive round-trips between the VST host and the DSP's...

You can use XTC mode with a different interface. There is a recent thread about this.

Check the protools thread.

There are some problems though.