Non responsive system

[massusen]

Hi,

after a long time without using the Scope system, I fired it up yesterday to do some dubsub basses for a project. Started fine, project loaded my standard equipment, though I sensed some weirdness as synths gets loaded one after another and the DSP load meter doesn't move. Tried playing one of the synths over MIDI, doesn't react. Loaded a noddle in modular, no sound.

So, anyone had the same experience? Software error? Hardware? As I*m still running v. 4 upgrading to 5.5 seems as the obvious step, but not if it's selfevident that the hardware somehow has malfunctioned...

Running a two card setup - Pulsar and SRB, on a 4 core Win machine. This setup has worked earlier, even though it was... almost two years since I used it.

M

[at0m]

What does your samplerate window say? Maybe you had the Scope system slaved to an external source which is no longer connected, and the samplerate is idling?

[Mr Arkadin]

Were the cards freshly installed or have they been sitting there for a while? Maybe give the contacts a clean and wiggle the boards in their slots a bit to ensure good contact. Do the same to the STDM connectors too.

PS. If you can send me the link to the Scope 5.5 upgrade I would be very happy.

[massusen]

Hehe, well I obviously revealed how updated I am. The samplerate is a safe bet. Gonna try that. Thanks!