PlanetZ forums - scopeusers.com

The meter bridge has the ability to connection to any point in a project but does not show the connections with wires. I would like to be able to do something like that for a "solo" device. Like solo on a mixer. This would really clutter up a project. Is there a way to route invisibly the way the meter bridge does?

If you connect to Direct Outs, then "Hide" them again, the wires will be hidden. That's the only occasion I remember where you can hide the wiring. AFAIK, for anything else, S|C would need to change the OS.

If I am creating a device, can I designate outputs as direct outs so they can be hidden?