PlanetZ forums - scopeusers.com

Hi all !
I´ve got a minor issue here , I´m running two 20" monitor. Everything works just fine exept that everytime
I start up the system my second monitor doesn´t remember my screen resolution "1440*900".
I have to change it everytime ? All the monitor drivers are installed and I can´t figure it out ????

Anyone ...
/tuzzan

Check if the "BAse video" is uncheck.
run -> msconfig -> boot -> "Base Video" (uncheck it)

Thanx for the quick reply netguyjoel , I´ll give it a try .

Good Night from Sweden !



/tuzzan

Hi again !

the "BAse Vidio was unchecked
hhmm ?


/tuzzan

What graphics card are you using, and what version of drivers?

Hi all !

Yes ! after some fixing with the drivers , I finally find a new on and everything is back
in order.

Tanx for the tips !