Page 1 of 1
Look-ahead (delay) device
Posted: Tue Mar 06, 2007 11:20 am
by voidar
It would be nice to have a simple device that lets you delay a signal some msecs.
For now I have to use a standard Gate and conigure it to be open at all costs. But it might be doing something to my signal still. I don't know. I would just like a simpler device.
One controll -> delay in ms.
Posted: Tue Mar 06, 2007 11:58 am
by hubird
there is such a tool, I'm not at my DAW, but it was f.e. mentioned during the phasecancelling discussions
Posted: Tue Mar 06, 2007 1:34 pm
by Immanuel
I believe RedMuze made a small 200sample delay.
Posted: Tue Mar 06, 2007 2:22 pm
by wolf
you can use any delay if you set the dry and feedback value to zero.
Posted: Tue Mar 06, 2007 2:54 pm
by voidar
Yes, I know of the sample-delay, and I've used it. But I think 200smpl is too little for some transients?
And I would rather have one knob and not two (for both mono and stereo).
Posted: Tue Mar 06, 2007 3:22 pm
by hifiboom
the adern sample delay is 2000samples
2000 / 44100 s ~ 45 milliseconds max delay time....
Posted: Tue Mar 06, 2007 3:34 pm
by voidar
Or 41,6 in 48KHz
...
But this is only for modular. I've got flexor, I would just like one as a device too, one mono and one stereo.
Come one, you SDK guys can make one in seconds..!
delay plug
Posted: Wed Mar 07, 2007 12:58 am
by musurgio
Hi,
There is a free little delay plug called millidelay which I use !
It shows ms and samples !!
Great little one.
regards,
Dimitrios
Posted: Thu Mar 08, 2007 9:29 am
by voidar
Ah! Close one, but I think it will work fine. Could be cool to have a latency compensated stereo version too.
millidelay
Posted: Thu Mar 08, 2007 9:56 am
by musurgio
Hi Voidar,
If you choose two mono ones with exactly the same latency (we are talking down to samples here !!) then these two are definetely phase compensated for stereo use.
There is no chance while so small to be spread amoung two dsp's !
Regards,
Dimitrios
Posted: Thu Mar 08, 2007 4:13 pm
by Shroomz~>
Posted: Thu Mar 08, 2007 4:16 pm
by Mr Arkadin
Call me thick but what uses can this be put to?
Posted: Thu Mar 08, 2007 4:32 pm
by Shroomz~>
latency compensation for asio or external use. For sample delay compensation needed to align a Scope mixer mix which uses inserts or aux sends / returns that throw alignment off, etc etc ...
Posted: Thu Mar 08, 2007 4:54 pm
by voidar
It's for eating our DSP
Nah, my uses will be for look-ahead when using side-chaining.
Posted: Thu Mar 08, 2007 5:27 pm
by Shroomz~>
voidar wrote:It's for eating our DSP
It's not that heavy on dsp
