the scope4 manual says in the i/o section: s/mux available on pulsar2 and recent scope hw only.
has anybody experienced s/mux to be available on recent scope home adat i/o boards? I have a scope home board, that doesn't run with my (obviously older) adat extension (while the extension itself runs fine with a luna2 and a powersampler as well, and there is no s/mux available, as expected
.that consequently leads to my next question: is there such thing as adat extension hw revision 1.4 or greater? my older cards are both rev 1.3, and so is the adat expansion mentioned above. the scope home board is rev 1.4, and the adat ports and the additional zlink port won't show up. they do if connected to one of the rev 1.3 boards, so the extension seems ok.
I already asked cw support months ago, but since there was no reply maybe I can get some help here...
-greetings, markus-