PlanetZ forums - scopeusers.com

hyperthreading work fine with multiple scope cards?
I want upgrade my p4 2.8 rambus to p4 3.6 HT singlecore,I have see in daw of my friend with HT enable(p4 3.2) and pulsar 2 good performance bat with multiple scope cards work fine HT??

It works fine here with two cards.

Actually my system has some minor issue; it usually happens after more than 1 hour work with CPU load at 40% (using HT, of course), so I think about an hardware related issue, like too high temperature reached, or PSU fault.
Being a sporadic issue I did'nt seriously monitor it yet...


<font size=-1>[ This Message was edited by: Cochise on 2006-05-26 05:32 ]</font>