PlanetZ forums - scopeusers.com

Hi

I know, that i could search the forum for my Questions.
But in english its a bit too difficult to read out what i need and what i do not need.

So...

Like written in the Subjekt i´ve got PCI Master overflow after loading the secound masterverb pro in an ->empty<- projekt.
After pressing retry i could load a third...
same Window!
load the fifth masterverb it do not help to press retry the window comes up again and again...

Could that be a CardError?
On creamware account the card is named scope !NFR! what does that mean? (!NFR!)
Its an old card.

(! Not For Reverb ! xD)

Is there a Tool for monitoring PCI bus?

I´ve tried every Pci slot / I´ve set the Graficcard latency to 64 (perhaps wrong dont now) / disabled everything in Bios / no irq problems ( irq 16 or 17 if i remember right)

My System:

Athlon64 3800+ x2 / Epox 9nda3 (nforce3 ultra) / 1 gig ram / 1 Pulsar Scope (15DSP)
nvidia 6800 AGP

Thx for Help

sorry for my english!!!

<font size=-1>[ This Message was edited by: AndreL on 2006-03-16 15:21 ]</font>

I think i am wrong here.
copied it to Problem Solving...

if u want to reply please klick here:
http://www.planetz.com/forums/viewtopic ... &0&start=0