Page 1 of 1
Posted: Mon Dec 29, 2003 4:52 pm
by mikem
I record through pulsar II card into triple dat running win98 and lastest versions of software. I keep getting error that says "float point divide by zreo" and then asks for triple broad drivers (even though im not using tripl board) please heeeellp!
thanks to all
Posted: Fri Jan 02, 2004 8:19 pm
by astroman
as far as I remember you have to shut off the PC if that happens, reboot wasn't enough.
The thing is a little bitchy about installation, so if you run into this constantly it may be better to reinstall.
It's not the most convincing mixture of native / DSP processing.
I like the handling of TripleDat very much, but sometimes it seems to develope it's own mind
I'm currently using my 'messy' setup, the clean one's on another HD, but in this installation it's almost unusable.
welcome on board, btw
cheers, Tom