I recently had to re-install Pulsar, which I did off my old version 1.1 CD. Obviously I want to get back to using version 2.1 which I had been using, but does anyone know if I can make the jump from 1.1 to the 2.1 update that Creamware has on its web site? It says "Pulsar v2.01 full version" however the read-me file associated with it says:
"To be able to run the Pulsar v2.01 update, Pulsar v2.0(a/b) must be installed at least! The CD version is a full installation and does not require a previous installation."
So I'm not sure if the downloadable update can stand alone, or if I need to have v2.0(a/b) installed first.
If anyone knows the answer to this, thanks in advance for your reply.
Brian B.
Re-installing Pulsar
-
Guest
Subject: yess! 
)
yess, it´s like you have mentioned!
it´s standing in the line: you have to install first a complete install 2.0a/b before you can update to 2.01... i had the same problems always when i was reinstalling my system datas...
for me it´s like this
cd-version 1.2 install
update 1.3 install
update 1.3... install - i don´t know really
update 2.0 install
update 2.0a install
update 2.01 install
it´s fucking lame, but for me it´s the way ---- grhhhrrr!
t.
)yess, it´s like you have mentioned!
it´s standing in the line: you have to install first a complete install 2.0a/b before you can update to 2.01... i had the same problems always when i was reinstalling my system datas...
for me it´s like this
cd-version 1.2 install
update 1.3 install
update 1.3... install - i don´t know really
update 2.0 install
update 2.0a install
update 2.01 install
it´s fucking lame, but for me it´s the way ---- grhhhrrr!
t.
-
Guest