50% DSP, but no placement possible ?

[fra77x2]

I will try to fix my paypal and we talk then. Of course I have no problem sharing knowledge especially about scope.

[valis]

Sounds good.

[Liquid EDGE]

The only time I start to manually assign stuff is if I run into a run out of sat connection or some other “complaint”..

Though it’s hard to see what’s exactly sitting in each dsp..

So I just assign to whatever dsps that a free/low load until it works. (And remove anything in the project window I’m not actually using, need right then)… if I can’t get it to work I give up.

That’s as far as I go with it. (Along with using the picture of the dsp layout)

So would be nice to know more about manual assignments!!