Modutf

[fra77x]

utf

[Roland Kuit]

Yes, it works fine
I did midi out from your shell to Mod IV midi in.
Midi in to a drum module and a got a pattern.

[fra77x]

When you change values in the mds-8 sequencer does it works ok?

[Roland Kuit]

Ah, sorry to busy for that. Just tested trigger pulses.

[djmicron]

it works at first load and changes are working.
After saving the modular and loading it again, it works with the actual sequence, but changes aren't working.
I can apply changes only by switching project samplerate master|slave back and forth, or by assigning the modular to a new dsp.

[fra77x]

Because it is a mdl* can you check if it works when you don't save again the device?
In my system it works even if i save it again. (but i haven't reload it)

* i mean you can make changes and just save the project without saving the device

Do you think i should upload that mod2 shell empty or is it ok that way?

Thanks

[djmicron]

leaving the mdl as is, it works, tried to save the project, closing scope, reopening scope, loading the project and it works fine.

Then i tried to load the pattern sequencer and i get some dsp load/communication error messages.

We could load it inside another modular shell with specific in/out routing to manage the pattern seq modules.

Good job, at least it works on the xite.

[fra77x]

Thank you,

yes i'll try to see the pattern sequencer now.

Anyway,
Enjoy...

[fra77x]

I upload here a modular shell the old Electra. The sequencers are working and the pattern sequencer.

I assigned it to dsp 6.

Enjoy

[djmicron]

very good.

[fra77x]

Modular seqs timing and feeling is best.

Great we have them on xite again!

[dawman]

Thanks 4 this.

[Liquid EDGE]

God i would love this!
Cant believe i missed it.

[jksuperstar]

+1

[David]

Me too