anyone good at maths?

Neutron · Post by **Neutron** » Sat May 11, 2002 7:52 pm

I have made a pitch detector that has an output signal that decreases as the pitch increases. the signal decreases by half as the frequency doubles. its not much use like that!

from that signal i need to get the opposite.

Im sure it is something obvious

i tried using the control modifier, I almost works but it is difficult to control (and asynchronous)

i hope that makes sense to someone!
thanks in advance
DeFex

non scopers, if you can work out the formula it is still good.
If i have a formula then i can usually figure it out as a circuit.

<font size=-1>[ This Message was edited by: defex on 2002-05-11 20:56 ]</font>

Neutron · Post by **Neutron** » Sat May 11, 2002 10:33 pm

never mind, me = teh dummy. output = max devided by input. hehe