Noah MIDI Question

Danimalia · Post by **Danimalia** » Mon Oct 01, 2007 2:04 pm

OK, so hopefully this isn't too stupid a question, but I can't seem to figure out for the life of me (or find in the manual) how to change presets when in MULTI mode. Whenever I throw a preset change message at Noah, it changes only the presets in the respective slots of a Multi Performance, not the overall preset number of the Multi performance.

This would seem a pretty basic feature and I'm sure I'm not doing something right, so any help would be greatly appreciated.

alfonso · Post by **alfonso** » Mon Oct 01, 2007 2:53 pm

You must change the program in the general channel that basically is the mixer's channel.
Obviously the reload of synths is slower than a preset change on the same synth...

Danimalia · Post by **Danimalia** » Wed Oct 03, 2007 2:23 pm

That certainly did the trick, thanks! I saw my Noah's mixer channel is set to 16 and sure enough, preset changes sent on channel 16 change the Performance presets (though a bit slowly, as you mentioned). Thank you so much!

alfonso · Post by **alfonso** » Wed Oct 03, 2007 4:46 pm

It is slow, but not so much as the redraw though....