I have been experimenting with CW's ability to control external synths w/ MIDI. The Lexicons are loaded with parameters and Mehdi's CC8, and CC5 can be used externally on these and the MIDI'd SE-1x hardware analog synth.
This could also be applied to John Bowens Solaris I hope. That would be completely astounding.
Whadya think John?
SpaceF's CC8 And JB's Solaris
-
dawman
- Posts: 14368
- Joined: Sun Jul 24, 2005 4:00 pm
- Location: PROJECT WINDOW
-
johnbowen
- Posts: 542
- Joined: Wed Mar 19, 2003 4:00 pm
- Contact:
You are asking about having the Solaris send out Midi CCs with the knobs and switches, etc.? I'm guessing it's possible, of course - but it's not at the top of our list, let's just say.
Because of the large number of parameters, the basic Editor will have to use NRPN (Non-Registered Parameter Number) MIDI messages. We could do something like Dave Smith does, where you have a basic set of CC numbers covered by the front panel knobs, and/or you use the NRPN messages, with a switch to select this in a Global page. But these are assigned internally by the factory - the user can't decide which controller number will be on each knob, etc., which is more of what I think you are wanting here.
Something for future discussion, for sure!
Cheers,
John B.
Because of the large number of parameters, the basic Editor will have to use NRPN (Non-Registered Parameter Number) MIDI messages. We could do something like Dave Smith does, where you have a basic set of CC numbers covered by the front panel knobs, and/or you use the NRPN messages, with a switch to select this in a Global page. But these are assigned internally by the factory - the user can't decide which controller number will be on each knob, etc., which is more of what I think you are wanting here.
Something for future discussion, for sure!
Cheers,
John B.