Can I change my I/O plate ??

Stompa81 · Post by **Stompa81** » Tue May 01, 2007 2:11 am

I was just wondering with my Scope Project card if I can change my classic I/O plate for a "plus" i/o plate??

If it is possible can I buy a plus i/o plate off someone ???

husker · Post by **husker** » Tue May 01, 2007 2:37 am

I've got a Plus plate on my Pulsar 2 which I would quite like to swap for a Classic, and you're not to far across the ditch (i'm in Wellington). PM me if you are interested.

Cheers, Wayne.

Stompa81 · Post by **Stompa81** » Thu May 03, 2007 11:54 pm

Wayne I sent u a pm

stardust wrote:it is possible

Is it just a case of simply swapping the plates over ?? Or do you have to re-install scope after the swap aswell??

hifiboom · Post by **hifiboom** » Fri May 04, 2007 1:56 am

not having done it yet
i would say :
no

it has nothing to do with the drivers....

ali · Post by **ali** » Fri May 04, 2007 8:51 am

All Pulsar 2/Scope project I/O plates are Interchangeable

you can swap your PLUS with Classic or Zlink or 24ADAT and vise versa.

husker · Post by **husker** » Fri May 04, 2007 2:17 pm

I hope it works!

I unplugged the i/o plate from my Pulsar 2 and powered it up again (I also have a Pulsar 1 and PowerSampler) - Scope still see's the Pulsar 2, but with no i/o - just acts like a DSP booster.

So I wired my ADA8000 up to Pulsar 1, re-routed and all good to go! This stuff is too smart sometimes. The flexibility we have is amazing.

Anyway, means I can do the swap with Stompa81 without any down time for either of us.

Stompa81 · Post by **Stompa81** » Fri May 04, 2007 9:59 pm

Talk about being at the right forum at the right time

husker · Post by **husker** » Fri May 04, 2007 10:50 pm

Most of life's problems can be solved at planetz

manfriday · Post by **manfriday** » Sat May 05, 2007 5:12 am

I've done it.
It works fine.