Master / Slave

arela · Post by **arela** » Wed Jan 25, 2006 12:57 am

When using SP/DIF IN, I have to set Scope as Slave to avoid clicking.
(cycling clicks it appears, maybe 20 s between them.)

When switching Pre off, I can make Scope Master again.
Is this normal?

I have a Aphex 207D PreAmp connected (OUT) to Pulsar sp/dif (IN).

alfonso · Post by **alfonso** » Wed Jan 25, 2006 1:06 am

Yes, or to say better, if you switch the Aphex off you have to make Scope master again to have a digital clock active. Normally the digital source must provide the digital clock.

MD69 · Post by **MD69** » Wed Jan 25, 2006 1:58 am

Hi,

Don't know about your hardware, but if you have synchplate and a wordclock entry on the preamp, you can solve your problem by connecting the wordclock and slaving the preamp to scope (scope being always then the sync master ).

arela · Post by **arela** » Wed Jan 25, 2006 2:33 am

Thanks both,
It's ok to know "what to do and why"