Scpe and UAD-1

Teto · Post by **Teto** » Tue Oct 04, 2005 4:51 am

HI! This is my question ...
I got Scope Z-link PCI board equipped with Luna 2496 converter, PC based on P4 3,2 GH, Mo.Bo Asus P4c800 Deluxe HT e ACPI mode, 1 GB Nanya 3200 ram + 1 GB Corsair Value 3200 ram, video board ATI Radeon 9200, one ATA 40 GB disk for programs and SO (XP pro with SP2 patch), two SATA 120 Gb disks for sound librarians and audio files respectively.
Does Creamware systems work with UAD-1 Universal Audio boards (Project and Studio Pack)?
What do you think about?
Thanks and best regards!

Post by **garyb** » Tue Oct 04, 2005 1:11 pm

many have used the uad card with scope(in the sequencer, of course).

samplaire · Post by **samplaire** » Thu Oct 06, 2005 11:21 am

I have UAD-1 + 2 CW boards and haven't had ANY kind of technical problem. UAD-1 latency depends on the latency of your ASIO card. The latency is always 2 times larger. So if you have 4ms in your CWA card then you have to expect 8ms in UAD plugs. But you have to remember some plugins are have very advanced architecture and cause larger latency. There is also another known problem with Logic - I have my CWA cards set to 4ms@44.1kHz and have UAD latency @25ms and can't go lower.

I have a Mac with MacOS 9 + Logic Pro

_________________

Sir samplaire scopernicus

<font size=-1>[ This Message was edited by: samplaire on 2005-10-06 12:22 ]</font>

Teto · Post by **Teto** » Fri Oct 07, 2005 7:06 am

Thanks! This place is always full of kind and expert guys!!!

samplaire · Post by **samplaire** » Fri Oct 07, 2005 10:56 am

New UAD software has been released yesterday. Unfortunately they dropped OS9 and Win95/98 support

<font size=-1>[ This Message was edited by: samplaire on 2005-10-07 12:00 ]</font>

samplaire · Post by **samplaire** » Fri Oct 07, 2005 12:57 pm

Regrettably!