pulsar, cubase and reason

Kalinski · Post by **Kalinski** » Thu Jan 27, 2005 1:54 pm

hi

i would like to be able to seperate outputs from cubase and reason in pulsar so i can use the pulsar effects etc. is this possible?

cheers

K

Mr Arkadin · Post by **Mr Arkadin** » Thu Jan 27, 2005 3:56 pm

This should be in the General SCOPE forum. See that bit under Tips & Tricks where it says, No questions here please...?

dubcotics · Post by **dubcotics** » Thu Jan 27, 2005 4:03 pm

hi,

for that you have the ASIO drives, provided REASON and CUBASE are switched to ASIO. Ah! you can use REASON along side with Cubase sx via REwire. you should be able to use both sequencers at the same time and consquently apply Scope fx, cheers.

didier,

ps: tho I haven't tried I guess it's done like that. Well someone will turn up with some better explanation.

Post by **hubird** » Thu Jan 27, 2005 4:35 pm

another one who asks for a tip in the T&T forum

dubcotics · Post by **dubcotics** » Fri Jan 28, 2005 4:11 am

hi,

don't be so sarcastic, the knows now where to post accordingly,

cheers,

didier.

dubcotics · Post by **dubcotics** » Fri Jan 28, 2005 4:13 am

hi,

don't be so sarcastic, kalinski knows now where to post accordingly,

cheers,

didier.

Kalinski · Post by **Kalinski** » Fri Jan 28, 2005 4:23 am

sorry about sticking this in the tips and tricks section. my brain was not working yesterday

Kalinski · Post by **Kalinski** » Fri Jan 28, 2005 4:28 am

I can split the outputs from Reason into Cubase, but i can't work out how to split those into pulsar?

From memory i used to use the bus in Cubase and that used to give me seperate outputs in pulsar.

because of computer problems (and lack of money)it has been a year since i have used pulsar regularly!

cheers again

wayne · Post by **wayne** » Fri Jan 28, 2005 4:43 am

Yep, open up as many asio channels as you need in sfp, then fire up cubase.

Activate your output busses (master panel) and assign tracks

King of Snake · Post by **King of Snake** » Fri Jan 28, 2005 9:48 am

btw. double-click the ASIO source/destiantion modules in SFP to set the number of available channels. Once you've done that, the channels will show up in Cubase as possible in-/output busses.

Post by **hubird** » Fri Jan 28, 2005 10:06 am

On 2005-01-28 04:13, dubcotics wrote:
don't be so sarcastic, kalinski knows now where to post accordingly,

I apology, but my post wasn't meant that heavy

the idea of 'I need a tip so I post it in the Tip forum' is rather funny to me

Lately someone named that reason

Ah, forget about it

dubcotics · Post by **dubcotics** » Sat Jan 29, 2005 11:43 am

peace!!