PlanetZ forums - scopeusers.com

That would be yes.

Does the Pulsar Card have to be installed for that to work? Thanks.

Can anyone help me with how to go about removing the scope software completely from my computer. I've taken out the card. I don't see anything in Add/Remove Programs so I'm confused.

When I try and load GigaStudio, it is still looking (and getting) a Scope error. I have a job in which I need ...

I never got it working. Too much going on. Blah blah. That said, I don't want to buy another card when I really love Pulsar and what it brings.

So I went - finally - into the manual and read that "this module is not yet supported under Windows 2000/XP." (In the I/O & Drivers PDF).

Is GigaStudio ...

Okay - here is the latest setup (that didn't work)

Midi A Source > Sequencer Midi Dest 1

I tested that I have sound via this source by playing a Pulsar synth.

When I try and then pull up GigaSampler, it:

1) Gives me an option to run dianostics mode because the system was not shut down properly ...

" giga dest must be present before opening giga"

I have a Giga Source going to the board, which I can only imagine are my Giga Outputs. I do not, however, see a Giga Destination as an option.


"you need a sequencer midi dest(at least one) to send midi to giga."

Again, I don't see a Giga In ...

"giga dest must be present before opening giga"

Do you mean the GSIF source? That is going into the Mixer.

Pulsar Midi A Source > Midi In on the STM 1632.
Nothing is Midi Out on the STM 1632.

Thomas

Your response reminded me that perhaps I should have Pulsar up and running with a Giga Driver installed in the mixer. So I did that. When I chose it, it automatically routed it to the mixer.

So now I'm back to installing GigaStudio. I make it throught the install and reboot the computer. It ...

I tried to Google the error but found nothing concerning scope/pulsar.

Thanks Chris. It seems like it might be a driver problem. But I don't see on the Creamware site where I can download the newest drivers.

Thanks,

Thomas

Hi. When I try to load GigaStudio Solo, I get a scope error (using Scope 4 Software).

"Scope Driver Ioctl (1036) returned error code -99"

The card is working fine by itself - just installed. But when I try and load Gigastudio, I receive the message.

Any ideas? I've looked to see what the driver ...