PlanetZ forums - scopeusers.com

5-10 mins is definately excessive, lol. Sorry I didn't realize it was THAT long. I think you should do some basic troubleshooting. First & foremost insure that you have ONLY the ASIO driver selected in Logic (audio driver page 2) and also insure it's using the Scope ASIO driver. Check your asio ...

Thank you very much I appreciate you answer.
- and then I must wait these 5 - 10 min. it takes, still I think it´s a long time. Longer than I ever have had to wait? Maybe it´s another thing I have to find out?
Cheers, Claus

I had to reinstall eveything and when started up again I took a war for me to open Logic. I can see that it is the ASIO contact that takes time.
What kind of ASIO driver is the best in SCope 4.5,?
-righ now I am using: ASIO1 24 bit , in my set up.
regards Claus

i had this problem once.
i have 3 boards: luna, pulsar1, pulsar1 SRB.
i pulled out one of the boards, reboot, everything was OK
then i reinseterd the board and rebooted: everything was OK!

I have formated the C drive and when I install the driver for Pulsar 2, the error message apears after the ...

i had this problem once.
i have 3 boards: luna, pulsar1, pulsar1 SRB.
i pulled out one of the boards, reboot, everything was OK
then i reinseterd the board and rebooted: everything was OK!

I have formated the C drive and when I install the driver for Pulsar 2, the error message apears after the ...

katano wrote:it's the firewire controller...

have you tried to reinstall sfp?

Yes I have tryed everything and I am going to formate the C drive now, to start up from clean disk, oh boy!

djmicron wrote:which os ? Windows XP professionel
which scope version ?

Scope 4.5
Please tell me, What is: IRQ 20 VIA OHCI Compliant IEEE 1394 Host Controller OK ?

On 2006-10-20 04:44, pacificband wrote:

On 2006-10-20 01:11, garyb wrote:
make sure that the card is fully seated in it's slot.

go to start/programs/accesories/system tools/system information/hardware resources/conflicts-sharing and tell me what, if anything, is sharing an irq with your scope ...

On 2006-10-20 01:11, garyb wrote:
make sure that the card is fully seated in it's slot.

go to start/programs/accesories/system tools/system information/hardware resources/conflicts-sharing and tell me what, if anything, is sharing an irq with your scope card.

<font size=-1>[ This Message was ...

On 2006-10-19 23:22, garyb wrote:
no driver installed?

The problem is, when I reinstall the driver the error massage appears
installation error/

Hardware version 3o detected. This Hardware requires a software update. Please consult the installation guide.

HELP!
I keep getting this error massage:
installation error
Hardware version 3o detected. This Hardware requires a software update. Please consult the installation guide.
I have tryed to uninstall for reinstall, but I keep getting this massage.
What is "hardware version 30"?
Regards, Claus ...